iPhone XR Screen Replacement Guide
Cracked your iPhone XR? Good news - the XR uses an LCD screen, making replacement parts more affordable than OLED models. This guide walks you through the complete repair process.
⚡ Protect Your Screen — Cheaper Than Repair
A quality case + screen protector is 5% the cost of one screen replacement.
📱 iPhone XR Display Specifications
- Display: 6.1-inch Liquid Retina LCD
- Resolution: 1792 x 828 pixels, 326 ppi
- Features: True Tone, Wide color (P3), Haptic Touch
- Type: LCD (not OLED) - more affordable parts
- Biometrics: Face ID
- Frame: Aerospace-grade aluminum
- Release: October 2018
🛠️ Tools Required
- Pentalobe P2 screwdriver
- Tri-point Y000 screwdriver
- Suction cup
- Plastic opening picks (6+)
- Spudger
- Tweezers
- Heat gun or hair dryer
📦 Parts Needed
- iPhone XR LCD Replacement Screen - $50-100
- Display adhesive strips
📋 Step-by-Step Instructions
Step 1: Power Off & Remove Screws
Power off your iPhone XR. Remove the two pentalobe screws at the bottom, on either side of the Lightning port.
Step 2: Heat & Open
Apply heat to the edges to soften adhesive. Use suction cup on the bottom half of the screen, create a gap, and insert opening picks.
Step 3: Separate All Edges
Slide opening picks around all edges. Be extra careful on the left edge - don't insert more than 3mm deep to avoid cable damage.
Step 4: Open Display
Swing the display open from the right side to about 90 degrees. Support it or use a repair stand - don't let it fall back.
Step 5: Disconnect Battery
Remove the tri-point screws from the battery bracket. Lift bracket and disconnect battery connector with a spudger.
Step 6: Disconnect Display
Remove the display cable bracket screws. Disconnect the three cables:
- LCD panel connector
- Digitizer connector
- Front sensor assembly connector
Step 7: Transfer Components
Move these from old screen to new:
- Earpiece speaker with sensor assembly (includes Face ID)
- Metal shield plates
Step 8: Install & Test
Connect new display cables. Reconnect battery. Power on and test:
- Display works with no dead pixels
- Touch responsive everywhere
- Face ID recognizes you
- Front camera works
Step 9: Seal & Finish
Apply new display adhesive. Close display firmly, pressing around edges. Replace bottom pentalobe screws.
✅ Post-Repair Testing
- ☐ Display shows full image, no lines/dead pixels
- ☐ Touch works in all corners
- ☐ Face ID enrollment and unlock work
- ☐ True Tone active (Settings → Display)
- ☐ Front camera takes photos
- ☐ Earpiece speaker works (make a call)
- ☐ Proximity sensor works (screen off during calls)
Need Professional Help?
iPhone XR repairs are straightforward but require care. Our technicians can complete this repair quickly with quality parts.
Get Pro Help →