iPhone Wireless Charging Not Working
iPhone 8 or newer not charging wirelessly? Here's how to diagnose and fix the issue.
As an Amazon Associate we earn from qualifying purchases. This costs you nothing extra and helps keep this site free.
⚡ Try Cleaning Before Paying for Repair
Lint and dust cause most charging issues. These tools fix it for $10.
Lint and dust cause 60% of charging issues — fix free
Counterfeit cables fail before the port does
Original Apple-rated power for proper charging
Microfiber + brush + alcohol wipes
🔍 Quick Fixes
- Remove case: Thick/metal cases block charging
- Center phone: Must be aligned with charging coil
- Check charger: Try different Qi charger
- Clean surfaces: Remove debris from phone back and charger
- Restart phone: Fixes software glitches
🛠️ Tools You'll Need
- Phone Charging Port Cleaning Kit (plastic picks)
- MFi-Certified Lightning/USB-C Cable
- 99% Isopropyl Alcohol
- Anti-Static Brush Kit
As an Amazon Associate we earn from qualifying purchases.
📋 Difficulty & Time
🔧 Diagnose & Fix Charging Issues: Step by Step
Step 1: Try a Different Cable AND Adapter
Cables fail more often than ports. Borrow a known-good cable from a friend, or grab a spare. Use a different wall adapter too — counterfeit chargers are a common silent killer.
Step 2: Inspect the Charging Port with a Flashlight
Hold the device under a bright light and look directly into the port. You're looking for:
- Gray pocket lint compressed against the back wall (most common)
- Bent or recessed pins (drop damage)
- Green corrosion on the contacts (liquid damage)
- Stuck-on residue from sticky drinks
Step 3: Clean the Port with a Plastic Pick
Power the device OFF first — this prevents short-circuits while you work. Then:
- Insert a plastic precision pick at a slight downward angle
- Work toward the back wall, then drag forward to pull lint OUT (never push deeper)
- Repeat from different angles — port lint is layered
- NEVER use metal — paperclips, needles, or pins will short the contacts
Step 4: Brush + Compressed Air
After picking visible debris, sweep the port with a soft anti-static brush, then short bursts (1 sec) of compressed air from 6 inches away. Keep the can upright to avoid propellant spray.
Step 5: Try Wireless Charging
If the device supports MagSafe/Qi: try wireless charging. If wireless works but wired doesn't, the port is dead — you need replacement (see escalation below). If wireless ALSO doesn't work, the issue is likely the battery or charging IC.
Step 6: Force Restart
Sometimes iOS/iPadOS gets stuck in a charging-block state. Force restart resets the power management chip:
- iPhone 8 and later: press Vol Up, then Vol Down, then hold Side until Apple logo
- iPad with no Home button: same as iPhone 8+
- iPad with Home button: hold Top + Home until Apple logo
⚠️ Common Mistakes to Avoid
- Pushing lint deeper instead of pulling it out
- Using metal tools (instant short risk)
- Skipping the cable test — cables fail more than ports
- Cleaning while the device is powered on
🏥 When to Call a Pro
If the port has bent pins, visible corrosion, or the contacts feel loose, you need a replacement (Apple: $129, third-party: $79–$99, AppleCare+: $99). Skip DIY for this — bent contacts can damage the logic board.
⚙️ Settings to Check
- Settings → Battery → Battery Health (check if degraded)
- Make sure not in Low Power Mode (can affect charging)
- Reset all settings as last resort
🔧 Hardware Causes
- Damaged charging coil: Located under back glass
- Back glass damage: Cracks can affect coil
- Logic board issue: Rare but possible
Hardware repair requires professional service.
🔧 Get Help
📞 Call: (856) 914-1074
PC Medics of NJ — iPhone repair experts
📦 Mail-In Repair Service
Not comfortable doing this yourself? Send your device to a professional repair shop.
🛒 Recommended Products
The #1 repair kit — 64 bits, pro tools, lifetime warranty
EZ Fit tray — foolproof install, 9H tempered glass 2-pack
Charge iPhone, Watch & AirPods — one compact cube